Craftmade MN44SS4 Installation Guide download pdf (Page 7)

6. Wiring. (cont.)

page 6

IN ORDER TO WIRE WALL CONTROL, remove

existing wall switch. Wire the WALL CONTROL

with wire connectors provided as shown in

diagram at right.

* Wrap each wire connector separately with

electrical tape as an extra safety measure. Gently

push wires and taped wire connectors into

outlet box.

Use a ballpoint pen or a small screwdriver to set

the code switches 1 through 4 on the wall

control. Factory setting is pre-set and not

recommended for use. Write down number

sequence for use in Section 10.

Note: Since this fan comes with a halogen bulb,

the dimmer switch (labeled D and X) has been

pre-set to the "ON" position (D). If you do not

wish to have dimming capability, please move

the switch to the "OFF" position (X).

Install one 12-volt battery (included) in wall

control. Attach wall control to outlet box and

secure with screws from original wall switch.

Attach front plate to wall control using 2 screws

provided in the wall control.

Important: Wall control will not function unless

battery is installed.

Modifications not approved by the party responsible for compliance

could void the user's authority to operate the equipment.

*NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

* Reorient or relocate the receiving antenna.

* Increase the separation between the equipment and receiver.

* Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

black (OUT to fan)

green

black

(AC IN from

breaker box)

black

(TO POWER supply)

(wiring for wall control)

black

green/

bare

ground

green/

bare

ground

outlet box

wall

control

plate

code

switches

12V battery

dimmer

switch

antenna

7. Canopy Assembly.

Raise canopy to hanging bracket and align

slotted holes in canopy with loosened screws

in hanging bracket. Twist canopy to lock.

Re-insert screws that were previously

removed (page 3, Section 4) and secure all

screws with Phillips screwdriver.

*Remember that antenna for remote control

receiver must rest outside of hanging bracket.

canopy

hanging bracket

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Comments to this Manuals

No comments

Craftmade MN44SS4 Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Household fans Craftmade MN44SS4