Craftmade MN44SS4 Installation Guide download pdf (Page 6)

page 5

5. Fan Assembly. (cont.)

With the hanging bracket secured to the outlet box and able

to support the fan, you are now ready to hang your fan. Grab

the fan firmly with two hands. Slide downrod through

opening in hanging bracket and let hanging ball rest on the

hanging bracket. Turn the hanging ball slot until it lines up

with the hanging bracket tab.

WARNING: Failure to align slot in hanging ball with tab in

hanging bracket may result in serious injury or death.

Tip: Seek the help of another person to hold the stepladder

in place and to help lift the fan up to you once you are set on

the ladder.

Replace vice on safety cable and adjust safety cable length by

loosening screw and nut on the safety cable vice and pulling

on the cable. Adjust slack in cable to a hands length and

secure vice by tightening screw and nut securely. [Refer to

drawing at right.] The loop at the end of the safety cable

should just fit over the threads on the wood screw. Test safety

cable by pulling on loose end with pliers. If the safety cable slips,

the screw and nut on the vice must be set tighter.

Find a secure attachment point (wood ceiling joist highly

recommended) and secure safety cable. It will be necessary to

use a heavy duty wood screw, washer and lock washer (not

supplied) with the safety cable loop. Extra cable slack can be

left in ceiling area.

yoke cover

safety cable loop

canopy

wood ceiling joist

hanging ball slot

hanging bracket tab

safety cable

wood screw

and washer

nut

screw

6. Wiring.

CAUTION: Be sure outlet box is properly grounded and

that a ground wire (GREEN or Bare) is present.

Make sure all electrical connections comply with Local

Codes or Ordinances and the National Electrical Code. If

you are unfamiliar with electrical wiring or if the

house/building wires are different colors than those

referred to in the diagram to the right, please use a

qualified electrician.

When downrod is secured in place on the hanging

bracket, wire the RECEIVER with wire connectors

provided as shown in diagram at right.

Tip: While you are wiring, keep in mind that wires

must not obstruct receiver from sliding into hanging

bracket.

* Wrap each wire connector separately with electrical

tape as an extra safety measure.

Gently insert receiver (flat side up) into hanging

bracket and carefully push wires and taped wire

connectors into outlet box. Let antenna rest outside of

hanging bracket.

["Wiring" continued on next page.]

black

from receiver

from fan

from ceiling

from receiver

white

blue

black supply wire

ground (green

or bare)

white supply wire

white

AC IN N

AC IN L

receiver

black

white

(wiring for receiver)

ground (green

or bare)

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comments to this Manuals

No comments

Craftmade MN44SS4 Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Household fans Craftmade MN44SS4