Craftmade MN44SS4 Installation Guide download pdf (Page 4)

This fan can be mounted with a downrod

on a regular (no-slope) or vaulted ceiling. The

hanging length can be extended by purchasing

a longer downrod (0.5in. /1.27cm diameter).

Other installation, such as flushmount, is NOT

available for this fan.

Vaulted ceiling

angle is not to

exceed 25 degrees.

3. Installation Preparation.

4. Hanging Bracket Installation.

page 3

OFF

Installation requires these tools:

Phillips screwdriver, flat-head screwdriver,

adjustable pliers or wrench, stepladder, wire

cutters, and rated electrical tape.

To prevent personal injury and damage, ensure

that the hanging location allows the blades a

clearance of 7 feet (2.13m) from the floor and

30in. (76cm) from any wall or obstruction.

This fan is suitable for room sizes up to 225

square feet (20.9 square meters).

downrod

installation

flushmount

installation

blade edge

7 feet

(2.13m)

(76cm)

inches

Turn off circuit breakers to current fixture from breaker panel

and be sure operating light switch is turned to the OFF

position.

WARNING: Failure to disconnect power supply prior to

installation may result in serious injury.

Remove existing fixture.

WARNING: When using an existing outlet box, be sure the outlet

box is securely attached to the building structure and can support

the full weight of the fan. Ensure outlet box is clearly marked

"Suitable for Fan Support." If not, it must be replaced with an

approved outlet box. Failure to do so can result in serious injury.

CAUTION: Be sure outlet box is grounded properly and that a

ground wire (GREEN or bare) is present.

Locate screws in slotted holes on opposite sides of canopy and

partially loosen these screws. Remove the other 2 screws--save

for later use. Twist canopy to remove hanging bracket from

canopy.

Install hanging bracket to outlet box using original screws,

spring washers and flat washers provided with new or original

outlet box.* If installing on a vaulted ceiling, face opening of

hanging bracket towards high point of ceiling. Arrange

electrical wiring around the back of the hanging bracket and

away from the bracket opening.

*Note: It is very important that you use the proper hardware

when installing the hanging bracket as this will support the fan.

hanging bracket

outlet box screws

spring washers

flat washers

12 ft. - 15 ft.

(3.66m - 4.57m)

1 2 3 4 5 6 7 8 9 ... 21 22

Comments to this Manuals

No comments

Craftmade MN44SS4 Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Household fans Craftmade MN44SS4