Craftmade VS60SS5 Installation Guide download pdf (Page 9)

page 9

11. Wall Control Operation.

10. Automated Learning Process./

Activating Code.

CAUTION: The remote control transmitter can be

programmed to multiple receivers or fans. If this is not desired,

turn wall switch off to any other programmable receiver or

fan.

This remote control transmitter is equipped with 16 code

combinations to prevent possible interference from or to

other remote units such as garage door openers, car

alarms or security systems. If you find that your fan and

light go on and off without using your remote control,

simply change the combination code in your remote

control transmitter (and wall control). To set the code,

perform these steps:

Remove battery cover from back side of transmitter.

Use a ballpoint pen or a small screwdriver to set the code

switches 1 through 4 for the transmitter. Use the same

number sequence used when wiring the wall control in

Section 6 (page 6).

Note: The dimmer switch (labeled D and X) has been

pre-set to the "ON" position (D). If you do not wish to have

dimming capability, please move the switch to the "OFF"

position (X).

Install 12-volt battery (included) in transmitter and then

re-attach the battery cover.

IMPORTANT: Store the transmitter away from excess heat

or humidity. To prevent damage to transmitter, remove the

battery if not used for long periods.

Restore electrical power and then set slider switch on wall

control to the ON position. Within 30 seconds of turning on

the wall control, press and hold the "OFF" button ( ),

located on the front of the transmitter, for 5 seconds or

until lower light on fan blinks twice. Test the fan and light

functions to confirm the learning process is complete--see

Section 13.

transmitter

(front)

battery

cover

12V battery

dimmer

switch

code

switches

transmitter

(back)

ON/OFF slider switch - turns wall control ON or OFF

HIGH button - turns fan to HIGH speed

MED button - turns fan to MEDIUM speed

LOW button - turns fan to LOW speed

OFF button - turns fan OFF

L1 button - turns lower light ON/OFF when pressed once; dims

lower light when pressed and held down

L2 buton - turns upper light ON/OFF when pressed once; dims

upper light when pressed and held down

REV button - used to REVERSE blade direction (fan must be set on

low before reversing blade direction)

L1L1 L2L2

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Craftmade VS60SS5 Installation Guide Page 9

Comments to this Manuals