Craftmade AT52 Installation Guide download pdf (Page 7)

page 6

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket

and remove screw closest to the open end of the

hanging bracket. Partially loosen the other screw.

Lift canopy to hanging bracket. Place rounded part

of slotted hole in canopy over loosened screw in

hanging bracket and push up. Twist canopy to

lock. Re-insert screw that was removed and then

tighten both screws securely.

Slide canopy cover up to canopy, aligning rounded

part of slotted holes in canopy cover with screw

heads in bottom of canopy. Turn canopy cover to

the right (clockwise) until it stops.

canopy

screw

canopy cover

hanging bracket

screw

8. Blade Assembly.

motor housing

blade arm

blade

blade arm screws

lock washers

blade attachment

screws and washers

plastic

motor

lock

Time Saver: Washers for blade screws can be set

on each blade screw prior to installing blades.

Locate 15 blade attachment screws and washers

in hardware pack. Hold blade arm up to blade

and align holes. Insert 3 blade attachment

screws (along with washers) with fingers first

and then tighten screws securely with a Phillips

screwdriver. Repeat for the remaining blades.

Remove blade arm screws and lock washers

from underside of motor. If plastic motor locks

are installed with blade arm screws, discard

plastic motor locks (save blade arm screws and

lock washers to secure blade arms). Align blade

arm holes with motor screw holes and attach

blade arm with lock washers and blade arm

screws. [Note: Use slot located on switch

housing plate for easy access to motor screw

holes with screwdriver.] Before securing screws

permanently, repeat with remaining blade arms.

Securely tighten all screws.

Important: Tighten blade arm screws twice a

year.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

Craftmade AT52 Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Household fans Craftmade AT52